This B series of rubber moulded subsea bulkhead connectors is available with 2, 3 or 4 contacts and a maximum pressure rating of 10,000 psi. The connectors have 16 AWG pigtails and are supplied with aluminium bronze housings as standard. We offer an optional 316 stainless steel housing.
Only install with the pigtail on the low pressure side of the bulkhead or vessel. The pigtail-side pressure must not exceed the pressure applied to the connector side.
We stock the range of corresponding 230 volt/15 Amp rated cable connectors, also known as eo connectors.
For situations where mated connectors may be under mechanical stress, optional locking sleeves are available to maintain good electrical contact for many but not all connectors – see product matrix. For standard series connectors, the LS series locking sleeve must be fitted to the cable prior to installation.
The subsea connectors use a proven water expulsion mating process achieving ratings of up to 10,000 psi. Electrical power must be off before connecting or separating any of these products.
All dimensions are nominal.
